JET-PRO for Active Wear Heat Transfer Paper

JET-PRO® for Active Wear transfer sheets can be used for the following materials
Recommended for light colored synthetic fabrics only.  Applies to polyester, Lycra, Spandex and blends.  Not recommended for 100% cotton.

Application Instructions
1. Design or select your design on your computer.
2. Mirror the image.
3. Load the paper into the printer so that the image will appear on the coated side of the paper.
4. Print the design and allow it to dry.
5. Trim away the unwanted areas of the transfer if desired.

Heat Press Application
1. Preheat the heat press to 375 degrees Fahrenheit.
2. Set the press for HEAVY pressure.
3. Preheat the garment for a few seconds to remove wrinkles and moisture.
4. Place the transfer on top of the garment with the image side down.
5. Cover the entire image area with a teflon sheet if desired.
6. Press for 20 - 25 seconds.
7. Remove paper while still HOT.

Storage:
Store Jet-Pro for Active Wear transfer papers in a cool, dry area and do not remove from carton or poly bag until you are ready to use.

Washing Instructions:
Turn garment inside out and wash in cold water using a mild detergent.
Do not use bleach.
Dry on low heat setting.
Do not iron directly on the transferred area.

Test Application:
We thoroughly test each of our products on various substrates using different transfer equipment. However, it is impossible for us to duplicate all variables using all substrates and transfer equipment. Therefore, it is essential that you test the paper prior to production using your equipment, methods, and substrate material. Heat presses vary in accuracy. Conduct tests to determine the best time and temperature to use with your equipment. Please keep in mind that the Seller’s and Manufacturer’s maximum obligation shall be to replace any paper that has proven to be defective. Neither the Seller nor the Manufacturer shall be liable for any injury, direct or consequential, arising out of the use of, or inability to use this paper.