HEAT PRESS INSTRUCTION
PRINTING INSTRUCTIONS:
1. Print the image in reverse/mirrored format.
2. Trim away the unprinted areas of the transfer if desired.
PRE-TRANSFERRING INSTRUCTIONS:
1. Prepare the substrate by ensuring the surface is clean, dry and wrinkle free.
TRANSFERRING INSTRUCTIONS:
1. Place the transfer on top of the garment with the image side touching the substrate (backing paper is facing you).
2. Press 30 seconds @ 375°F using medium/heavy pressure.
3. Peel the paper while still hot in a smooth even motion. (Paper may be peeled at any temperature, depending on what end ‘feel’ results are preferred).
4. For best “hand”, stretch the garment while hot.
HAND IRONING INSTRUCTIONS
PRINTING INSTRUCTIONS:
1. Print the reversed/mirrored image on the coated side of the paper.
2. Trim away the unprinted areas of the transfer.
PRE-TRANSFERRING INSTRUCTIONS:
1. Preheat iron to highest setting – do NOT use steam (empty all water).
2. Iron on a SMOOTH HARD surface; do NOT use an ironing board.
3. Place a pillowcase on the surface and iron the pillowcase removing any wrinkles.
4. Place substrate on pillowcase and iron it to remove wrinkles.
TRANSFERRING INSTRUCTIONS:
1. Place image on top of garment with image facing down (backing of paper is facing you).
2. Using 2 hands, using heavy pressure slide the iron up and down (vertically) over the entire image for 90 seconds, then repeat going from left to right (horizontally) for 90 seconds.
3. Peel the backing paper off the image immediately after completion of ironing.
*for smaller transfers one-half or less, the ironing time is reduced to ironing vertically 45 seconds and horizontally 45 seconds. If the transfer area is smaller than the iron, iron for 30 seconds with heavy pressure.
WASHING INSTRUCTIONS:
Turn garment inside out and wash in cold water using a mild detergent. Do not use bleach. Dry on low-heat setting. Do not iron directly on the transferred area. IMPORTANT: Heat presses vary in accuracy. The sellers and manufactures maximum obligation shall be to replace any paper that has proven to be defective.
STORAGE:
Store JET-PRO® SofStretch Heat Transfer Papers in a cool, dry area and do not remove from carton or poly bag until you are ready to use.
TEST APPLICATION:
We thoroughly test each of our products on various substrates using different transfer equipment. However, it is impossible for us to duplicate all variables using all substrates and transfer equipment. Therefore, it is essential that you test the paper prior to production using your equipment, methods, and substrate material. Heat presses vary in accuracy. Conduct tests to determine the best time and temperature to use with your equipment. Please keep in mind that the Seller’s and Manufacturer’s maximum obligation shall be to replace any paper that has proven to be defective. Neither the Seller nor the Manufacturer shall be liable for any injury, direct or consequential, arising out of the use of, or inability to use this paper.
